The Loctite 30 ml PUR Dispense System is designed to dispense dots or beads of Loctite PUR Hot Melt adhesive products packaged in 30 ml syringe barrels. The system consists of a Controller, Dispense Head and Pre Heater (each purchased separately). The controller is an electro-pneumatic device to precisely control the amount of air pressure applied to the syringe barrel for a set time period to deliver a consistent amount of adhesive each time the system is actuated. The Controller has two heating circuits that can be used to heat two Dispense heads at the same time or (1) Dispense Head and (1) Pre-Heater. The system is designed to be used with Loctite Benchtop Robots or can integrate into any stationary work cell.
The Loctite SD15 Heat Controller and SD15 Tip Heater are accessories for this PUR Dispenser. The system keeps needle warm when the PUR dispenser is not being used which will enhance the first piece’s performance when going back to work.
Product Features:
Integrated dispense time control, pressure control, and temperature control features into one system.
Digital control for dispense head amd pre heater temperature and dispense timer.
Analog air pressure regulator for syringe pressure control. 0-100 psi (7 bar).
Dispense sequence can be foot switch actuated or externally actuated via a PLC.
Auto dispense mode for timed dispense control of beads or drops.
Manual dispense mode for variable volume applications.
PTFE safety shroud on dispense head.
Reduced material change-over time when used with 30 ml PUR Pre Heater.
